Finding a lost handset, Using an optional headset – Uniden DECT4066-3 User Manual
Page 27
25
When you get a Call Waiting call, the phone sounds a tone and
displays any CID information received for the waiting call.
To answer a Call Waiting call, press
FLASH
on the base or
TALK/
FLASH
on a handset. The phone company automatically puts the
current call on hold and switches you to the waiting call.
Use
FLASH
and
TALK/FLASH
to switch between the two calls;
remember, each time you switch, there is a short pause before
you're connected to the other caller.
Finding a Lost Handset
With the phone in standby, press
INTERCOM/HOLD
on the base. Select
the handset you want to find, or select All to page all handsets at the
same time. The paged handset(s) will beep for 1 minute or until you
press
INTERCOM/HOLD
again or press
TALK/FLASH
followed by
END
on
the handset.
Using an Optional Headset
You can use a standard 2.5 mm telephone
headset with your cordless handsets. To
purchase headsets, contact the Parts
Department (see the front cover).
To install a headset, remove the headset
jack cover and insert the headset plug into
the jack.
Just make and receive calls as usual, and
use your headset to talk to the caller after the call connects.
When you connect a headset, the handset automatically mutes
the earpiece and speaker. To re-activate the earpiece or speaker,
just unplug the headset.
(Belt clip
hole)