Universal Remote Control (URS) SL-9000 - Manual (Page 18)

8 Press and hold the DEVICE button and the SEL/PLAY
button simultaneously, once again. SAVED will flash
three times in the LCD and return to the DEVICE mode,
indicating that the programming has been stored.
Erasing Learned Functions
To erase learned functions, please refer to the following
procedures:
Erasing Individual Buttons:
1 Press the Device button for the mode where the learned
function has been stored.
2 Press and hold the Device and the SEL/PLAY buttons
simultaneously, for about 3 seconds, until the LCD
shows LEARN.
3 Press and release the button to be erased. The LCD will
show READY.
4 Press the LIGHT button. The LCD will flash ERASE,
CLEAR
, the Device Mode and then return to LEARN.
Repeat Steps 3 and 4 for any other buttons to be erased.
5 To return to the normal operating mode, press the
Device and the SEL/PLAY buttons simultaneously.
The learned functions on the selected buttons have now
been erased. The preprogrammed functions for these
buttons will now operate on the remote control.
17 17
Using Your Remote