Tripp Lite NETCOMMANDERTM B072-016-1 - Manual (Page 8)

8
To cascade two or more NetCommander KVM switches, follow the connections in the figure
below.
Setting the different OSD display hotkeys is explained on page 11.
Figure 8 Cascading NetCommander KVM switches
Switch between the connected computers using any of the following methods:
• The OSD (On Screen Display)
• Keyboard hotkey commands
• Manual selection buttons on the front panel
The OSD is also used to adjust various settings.
The illuminated LED of the top row of LEDs identifies which computer is currently selected.
To switch to the next computer, press and release the [Shift] key, then press the [+] key.
To switch to the previous computer, press and release the [Shift] key, then press the [-] key.
Note! You can use the [+] key of the alphanumeric section or of the numeric keypad on
a US English keyboard. With a Non-US English keyboard, use the [+] key of the
numeric keypad only.
Installation
(continued)
Cascading NetCommander KVM Switches
Basic Operation
Keyboard Hotkeys
Operation
SIU = Server Interface Unit
200512060 93-2520 B072 series OM.qxd 3/6/2006 11:17 AM Page 8