Trimble Outdoors 5700/5800 - Manual (Page 52)

4 General Operation
4 0 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
44.1
Logging internally
The 5700 receiver logs GPS data internally on a CompactFlash card.
You can then use the Trimble Data Transfer utility to transfer logged
data files to your office computer. The transferred files are in Trimble
DAT (.dat) format.
C
WARNING – The 5700 receiver allows for a maximum of 512 files on the
CompactFlash card, regardless of the card’s capacity. The file names must
be in 8.3 format, otherwise files copied to the CompactFlash card may
cause data corruption or loss of data when logging.
Data is logged using the current logging settings configured in the
receiver. Data files logged internally are named automatically.
To begin internal logging, press [D] . The Logging/Memory LED lights up.
To stop logging, hold down [D] for at least two seconds. The
Logging/Memory LED turns off.
Note – When the CompactFlash card is full, the receiver stops logging
data, and the Logging/Memory LED switches off. Existing data files are
not overwritten.
Approximate storage requirements for different logging rates are
shown in Table 4.2. The values shown are for a one-hour logging session
with six satellites visible.
Table 4.2 Storage requirements
Logging rate Memory required
10 Hz 2,588 KB
1 Hz 335 KB
5 seconds 87 KB
15 seconds 37 KB