Trimble Outdoors 5700/5800 - Manual (Page 157)

5700/5800 GPS Receiver User Guide 1 45
Default Settings 1 8
5800 GPS Receiver Oper
ation
18.2
Resetting to Factory Defaults
To reset the 5800 receiver to its factory defaults, do one of the following:
• Press and hold down [P] on the 5800 receiver for 15 seconds.
• In GPS Configurator select the General tab and then click Reset
Receiver .
182.1
Default behavior
The factory defaults specified above are applied whenever you start the
receiver. If a Power Up file is present in the receiver, its settings are
applied immediately after the default settings, so you can use a Power
Up file to define your own set of defaults.
Input Setup: Station Any
NMEA/ASCII (all messages) All Ports Off
Streamed output All Types Off
Offset = 00
RT17/Binary All Ports Off
Reference position: Latitude 0°
Longitude 0°
Altitude 0.00 m HAE
Antenna: Type 5800 Internal
Height (true vertical) 0.00 m
Group All
Measurement method Bottom of mount
Table 18.1 Default settings (Continued)
Function Factory default