3 connection to the control signal terminal – Toshiba MP8640 User Manual

Page 22

Downloaded from Projector.com

™

Multimedia Projector MP8640

5.3 Connection to the Control Signal Terminal

ADB mouse

ADB port

D-sub 15pin (Female)

PS/2 mouse

PS/2 port

D-sub 15pin (Female)

Mouse emulation

(1) While the projector and computer are turned OFF, connect the projector and the mouse terminal of

computer using an appropriate cable. (PS/2, Serial or ADB)

(2) Turn ON the projector.

(3) Turn ON the computer.

(4) Select the correct mouse driver for the application. See computer's User Manual for this procedure.

Note:

In some Notebook computers which have internal pointing device, mouse emulation will not work unless
the internal pointing device is disabled. In this case, disable the internal pointing device in BIOS setting.
Check the computer's manual for procedure to follow to disable internal pointing device in BIOS setting.

Caution:

Turn off the power to both the projector and computer before connecting.
Connect the computer to the control terminal of the projector using the appropriate cable.