Toshiba MP8640 - Manual (Page 12)

Downloaded from Projector.com
© 3M 1997 3M ™ Multimedia Projector MP8640
3.2 Using the Projector
1
Turn the MAIN POWER switch of the projector on.
• The ON indicator will light up orange.
2
Open the lens shutter.
• Push down lens shutter switch to open.
3
Press the STANDBY/ON button.
• The ON indicator blinks (green) and then lights (green).
• The ON indicator will blink green during warm-up and lamp ignition.
4
Adjust the screen size using the ZOOM button.
5
Adjust the focus using the FOCUS button.
(1) Press the FOCUS button. The on-screen display shown on the right appears.
(2) Adjust the focus so that the picture is sharp using the FOCUS button.
6
Turn on all connected equipment.
The method of connecting various equipment, see section 2.3.
7
Press the INPUT button on the projector or the INPUT SELECT
(VIDEO or RGB) button on the remote to select the
source of the signal to be projected on the screen.
• The selected signal input is displayed at the bottom right of the screen. The
display will show the last selected input source before power was turned off.
RGB 1
11
4 5
1
2
7
5
4
2
Example on-screen display
Note: Make all cable connections and line hookups FIRST.
7 3