Toshiba RD-XS24SB - Manual (Page 32)

32
3: AV1 output setting
To select the video output type corresponding to your TV system. Be sure to make this setting if the recorder is
connected to your TV via the AV1(TV) socket using a SCART cable.
1 Press SETUP if the setup menu is not displayed.
2 Press / to select “Initial settings”, then press ENTER.
3
Press / to select “AV1 output”, then press
ENTER.
4
Press / to select the video output type
corresponding to your TV system, then press
ENTER.
Video : Select when connected to a normal TV.
S-Video : Select when connected to a TV compatible
with S video signals.
RGB : Select when connected to an RGB monitor.
• To exit the menu, press the SETUP button.
Note
• If the on-screen display disappears immediately after you select “RGB”, you can restore it by connecting the recorder using
the AV OUT VIDEO (yellow) jack.
Initial settings
e.g.
Video
S-Video
RGB
Channel setting
Video
Auto
AV2 input
Time & date setting Auto
Input signal PAL
AV1 output Video
1 Clock set position
On Just clock
1 2 3
4 5 6
7 8 9
+10 0
TV DVD
INPUT SELECT
CHANNEL
MODE
RETURN
SLOW/REV FWD/SLOW
PLAY
STOP
PAUSE
REC
SKIP REV SKIP FWD
–ADJUST ADJUST+
TV/DVR DELETE
CLEAR
EXIT
ENTER
QUICK MENU
OPERATION
INSTANT
SKIP
INSTANT
REPLAY
NUMBER
HDD DVD
TOP MENU MENU
MENU TIMESLIP
CHANNEL VOLUME INPUT SELECT
OPEN/CLOSE
CHP DIVIDE ANGLE SUBTITLE AUDIO
REC MODE ZOOM SEARCH DISPLAY
PROGRESSIVE EXTEND SETUP REMAIN
Start
ENTER
ENTER
A: Initial settings (Continued)
Basic setup
RD-XS24SB_inst(E)_31-33 8/31/05, 5:41 PM 32