Toshiba RD-XS24SB - Manual (Page 30)

30
A: Initial settings (Continued)
Basic setup
O
1 BBC1
BBC2
I TV
CH4
CH5
2
3
4
5
Manual 1/20
Position Home CH
28
37
2-25
3-32
Station Skip
Off
Off
Off
Off
On
MFT
0
0
0
0
0
O FRAME/ADJUST
22
e.g.
6) Change the name of the TV station if necessary.
Every time you press ADJUST (– / +) button, the
name changes.
STB (Set Top Box):
Set this when you have the satellite receiver
connected through RF cable. (
page 19)
To set the recorder to receive broadcasts via the
connected satellite receiver, select position 6 of
“Position” at step 2).
While selecting “Station”, press the MODE button.
An input window appears. Press the / buttons
to select a character from 0-9, A-Z, –/+ and space.
To shift to the next, press the / buttons. When
complete, press the MODE button.
7) Press / to move the cursor to “Skip” and
press ADJUST (–/+) to set “On/Off”.
Unused channels are not displayed when you
select a channel with the CHANNEL buttons.
On : Skips this channel.
Off : Does not skip.
8) Press / to move the cursor to “MFT” and
press ADJUST (–/+) to adjust the receiving
condition.
Make an adjustment for a channel when the radio
signal is weak or when the reception is disturbed
with other radio signals. When this is adjusted, you
may get better image and sound.
9) Press , and set other receiving channels.
Repeat steps 2) to 8).
10) When you have finished setting the receiving
channels, press ENTER.
Read the message, and press the / buttons to
select “Yes”, then press the ENTER button.
The selected receiving channels are set and you
will go back to the “Initial settings” menu.
• To cancel, select “No”, then press the ENTER
button.
• To exit the menu, press the SETUP button.
Changing the preset station table
You can rearrange the preset TV stations according to
your own preferences position number assigned to the
station.
example: Swapping Position 1 and Position 4.
1) On the manual channel setting screen, press
/ to select the source position (e.g.,
Position 1) and press the MODE button.
The line for the selected position is highlighted.
2) Press / to select the target position (e.g.,
Position 4) and press the MODE button.
The channel in Position 1 and the channel in
Position 4 are swapped.
3 Clock set positon
1) Press / to enter the channel position of a
TV station which sends clock data.
For example, enter 1 if you select BBC1.
2) Press ENTER.
• To exit the menu, press the SETUP button.
4 Just clock setting
Press / to select “On” or “Off”, then press
ENTER.
Off : This feature is disabled.
To exit the menu, press the SETUP button.
On : The clock is automatically corrected
according to the clock data broadcast.
The daylight saving time can also be
adjusted.
Notes
• This function may not work correctly depending on the
signal conditon.
In this case, select “Off” to disable this function.
• This function will not work correctly unles the “Clock set
position” is set correctly.
• This function will not work if there is recording programmed
to begin or end within 1 hour and 15 minutes.
• Clock adjusting process will be stopped if the recorder’s
power turns on while it is in progress.
• This function will not work if the clock is ahead or behind
by more than 1 hour and 15 minutes.
RD-XS24SB_inst(E)_21-30 8/31/05, 5:41 PM 30