Toshiba D-VR3SB - Manual (Page 38)

38 - English
Allow you to setup the Audio device and sound status
depending on the audio system in use.
Note
Note
Digital Output
Setting Up the Audio
Options
Use the ❷ buttons to select the desired item.
Then press the ❿ or OK button.
1. PCM : Converts to PCM(2CH) 48kHz audio.
Select PCM when using the
Analogue Audio Outputs.
2. Bitstream : Converts to Dolby Digital/MPEG
Bitstream (5.1CH). Select Bitstream
when using the Digital Audio Output.
DTS
1. Off : Doesn’t output digital signal.
2. On : Outputs DTS Bitstream via digital out-
put only. Select DTS when connecting
to a DTS Decoder.
Dynamic Compression
1. On : To select dynamic compression.
2. Off : To select the standard range.
5
„ Press the RETURN or ➛ button to return to
the previous menu. Press the MENU button to
exit the menu.
„ When DTS soundtrack is played, sound does
output from Analog Audio Output.
With the DVD in Stop mode, press the MENU
button on the remote control. 1
Select “Setup” using ❷ buttons, then press
the ❿ or OK button.
2
Select “Audio” using ❷ buttons, then press
the ❿ or OK button.
Audio setup menu will be displayed.
3
PCM
Bitstream
Programme
Use ❷ buttons to select the desired sub menu
and press the ❿ or OK button.
4
Programme
S
ystem Setup