Tyco Voice Assisted Security Control Escort5580TC - Manual (Page 10)

10
Press [2]. The system will then announce the current volume setting in one of three ways:
“ Volume is low. To change volume, press [1].”
“Volume is Medium. To change volume, press [1].”
“ Volume is high. To change volume, press [1].”
Press [1] to toggle through the volume levels until the desired volume is selected.
Press [#] to return to the Special Functions menu.
5.3 Speech Rate Control
The speech rate of the system messages/prompts can be controlled with this feature.
With the system disarmed (Section 3.3—Disarming), access the security system (Section 2—
Accessing Your Security System) and select a partition (Section 2.5—If You Have a Two-
Partition System).
Press [✱]. You will hear the prompt:
“ For Special Functions, press [6]”
Press [6]. The system will prompt:
“ Enter your Master Code”
Enter the Master Code. The system will prompt:
“ For Speech Rate control, press [3]”
Press [3]. The system will then announce the current speech rate in one of two ways:
“Speech rate is fast. To change speech rate, press [1].”
“Speech rate is slow. To change speech rate, press [1].”
Press [1] to toggle between the speech rates until the desired rate is selected.
Press [#] to return to the Special Functions Menu.
5.4 Door Chime Feature
When the Door Chime feature is enabled, a series of beeps will sound from the system’s
keypads when certain specified zones are opened or closed. Your installer will inform you if
the Door Chime feature is enabled, and which zones on the system will activate the chime.
The Door Chime feature can be used to indicate the openings and closings of a door, such
as a back door that is not always in sight.
To enable the Door Chime feature you should first disarm your system (Section 3.3—
Disarming; depending on the control panel you have, your system may allow you to enable
the Door Chime feature without first disarming the partition). Access the security system
(Section 2—Accessing Your Security System) and select a partition (Section 2.5—If You
Have a Two-Partition System).
Press [✱]. You will hear the prompt:
“ For Door Chime control, press [4].”
Press [4]. You will hear one of the following:
“Door Chime is ON/OFF”
To turn the door chime on or off, press [4] again. To exit, press [#].
S E T T I N G E S C O R T 5 5 8 0 T C O P T I O N S