Teac CD-RW901 - Manual (Page 8)

1 − Introduction
TASCAM CD-RW901
The CD-RW901 has been designed for the playback of
CD-DA (standard audio) format discs and MP3 files
recorded on the discs using the ISO9660 format: In
addition to ordinary 5-inch and 3-inch CDs, it can also
play properly recorded CD-R and CD-RW discs.
Always place the compact discs in the trays with
their label facing upward.
To remove a disc from its case, press down on the
center of the disc holder, then lift the disc out, hold-
ing it carefully by the edges.
Avoid getting fingerprints on the signal side (the
non-label side). Grime and dust may cause skipping,
so keep discs clean and store them in their cases
when not being played. To clean the signal side of a
disc, wipe gently with a soft dry cloth from the cen-
ter towards the outside edge.
Do not use any record spray, anti-static solutions,
benzene, paint thinner or other chemical agents to
clean CDs as they could damage the delicate playing
surface. It may cause CDs to become unplayable.
Discs should be returned to their cases after use to
avoid serious scratches that could cause the laser
pickup to “skip.”
Keep discs away from direct sunlight, and places of
high heat and humidity. If left in such places, warp-
ing could result.
•
•
•
•
•
•
Do not affix any labels or stickers to the label side
of the disc. Do not write on the disc with a ballpoint
pen.
Do not insert discs that have adhesive remaining
from tape or stickers that have been removed. If they
are inserted into the player, they could stick to the
internal mechanism, requiring removal by a techni-
cian.
Do not use cracked discs.
Only use circular compact discs. Avoid using non-
circular promotional, etc. discs.
The CD-RW901 cannot play unfinalized CD-R/RW
discs.
Music discs with copy control, a copy-protection
system, have been released form several record
companies in an attempt to protect the copyright.
Since some of these discs do not comply with the
CD specifications, they may not be playable on the
CD-RW901.
•
•
•
•
•
•
Handling of compact discs
Environmental considerations
The CD-RW901 may be used in most areas, but to
maintain top performance, and prolong operating life,
observe the following environmental conditions:
The nominal temperature should be between 5°C and
35°C (41°F and 95°F).
Relative humidity should be 30 to 90 percent.
As the unit may become hot during operation, always
leave sufficient space above the unit for ventilation.
Do not install this unit in a confined space such as a
bookcase, and do not put anything on top of the unit.
•
•
•
Avoid installing this unit on top of any heat-generat-
ing electrical device such as a power amplifier.
Make sure that the unit is mounted in a level position
for correct operation.
NOTE
The voltage supplied to the unit should match the
voltage as printed on the rear panel. If you are in
any doubt regarding this matter, consult an electri-
cian.
•
•