Teac CD-RW901 - Manual (Page 29)

TASCAM CD-RW901
9
Automatic track division with trim function
When Auto Track is set to either Level or DD mode,
it is possible to trim the automatic track division point
using A_TRK TRIM option in the REC sub-menu (see
“Operation basics” on page 16). This function allows
you to slip the start time of the track increment forwards
or backwards.
NOTE
When Auto Track mode is set to Time, the value set
in Auto Track Trim is ignored.
The available trim value is from -125 through +125
frames.
Use the
MULTI JOG dial or MENU (+/-) key on the
remote control to adjust the trim value.
Automatically Incrementing index numbers
When recording with auto track function, when INDEX
INC is set to on (see “Operation basics” on page 16), the
unit overrides the setting of the automatic track division,
and instead of incrementing track numbers, it incre-
ments the index numbers within a track.
Use the
MULTI JOG dial or MENU (+/-) key on the
remote control to switch INDEX INC on or off.
Index XX where XX is index numbers will appear on
the display.
NOTE
The maximum index number within a track is 99.
When the unit reaches 99, it will increment the track
number and start assigning index numbers count-
ing from one.
Manually divide track
While recording is taking place, press the RECORD
key. The current track number is incremented by one.
For details of automatic track division while recording,
see “Automatic track division” on page 28.
NOTE
According to the “Red Book” (the specification for
audio CDs), a track cannot be less than four sec-
onds in length, and there can be a maximum of 99
tracks on an audio CD. Bear these limitations in
mind when adding track divisions.
This operation can not be applied while recording
track 99.
Time (Time track increment)
The track will be incremented when the time
set prior to recording using the menu item
“A_TRK_TIME?” has passed (see “Operation
basics” on page 16). The time can be set between one
minute and ten minutes in one minute increments.
• The A.TRACK indicator blinks during recording or when
in record ready mode.
This function can be turned on by pressing the
AUTO TRACK key on the remote control.
Manually incrementing index numbers
This function allows you to manually assign index num-
bers.
1. Select the INDEX option in the SYSTEM sub-
menu. Index> XXX will appear on the display.
Use the MULTI JOG dial or MENU (+/-) key on the
remote control to set the function on or off.
2. Start recording.
3. Press the CALL key at the point you want to
assign an index number. Index XX where XX
shows the number, will be displayed.
NOTE
The maximum index number within a track is 99.
When the unit reaches 99, it will increment the track
number and start assigning index numbers count-
ing from one.
5 − Recording