Tyco Electronics MM23772 - Manual (Page 34)

MM23772, Rev. B
34
7.12 KEYPAD FUNCTION COMMANDS (P7270 ONLY)
To perform a command from the keypad, use on of the following keypad commands:
Table 7-5: Keypad Function Commands
*0
Log-off command: *0## (logs the user off the system). See Section 7.7 for additional
information.
*1
Log-in command: *1 # ## (required for encryption). See Section 7.3
for additional information.
*4
SOI Mode: User is prompted with a channel to communicate with using the default profile.
Exit SOI Mode with *4#
*7
Initiate Selective Alert command: *7#[Choose Message]#. See Section 7.24 for
additional information. Exit SOI Mode with *4#.
*8 Radio-to-Radio Call command: *8#(PTT to dial).
*9
Public Switched Telephone Network (PSTN) Call command: *9 <telephone number>#(PTT
to dial) See Section 7.25 for additional information.
*32
Begin Manual Encryption command: *32#
1 – 16 digit encryption key for 128 bit encryption; 17 – 32 digit encryption key for 256 bit
encryption. See Section 7.27 for additional information.
*33 End Manual Encryption command: *33
*61 Initiate XCOV Mode: Extended coverage for individual users.
*62 Initiate XCOV-TG Mode: Extended coverage for talk groups.
*60 Exit XCOV or XCOV-TG Mode: Returns to the normal mode.
7.13 CHANGING THE ACTIVE PROFILE
The radio can store up to sixteen (16) standard profiles, one of which is the currently active profile. To
change the currently active profile:
1. Press the  or  buttons until “ProfileMenu” is displayed.
2. Use 
or
 to scroll through the list of available profiles.
3. Profile becomes active when selected for longer than 2 seconds, when the  is pressed, or when the
menu is changed using the

or

button. Press

to activate the selected profile.
7.14 CHANGING THE SELECTED TALK GROUP
Each profile stored in the radio can have up to sixteen (16) talk groups. One talk group within the
currently active profile is set as the “selected talk group.” To change the selected talk group, turn the
Group Selection knob on top of the radio.
7.15 ADJUSTING DISPLAY & BUTTON BACKLIGHT BRIGHTNESS
1. Press the  or  buttons until “Bright Menu” is displayed.
2. Use

or

to brighten or dim the display and button backlighting.