Tektronix 070-8811-08 - Manual (Page 73)

Reference
58 764 Digital Audio Monitor User Manual
Serial Port Submenu
The Serial Port submenu contains items used for setting the serial
port parameters and controlling the content of the session report. The
items and choices are listed in Table 10 and explained in the
subsequent paragraphs.
Table 10: Serial Port submenu items
Item Choices Factory setting
БББББББ
БББББББ
Flow Control
БББББББ
БББББББ
SOFTWARE; HARD-
WARE; BOTH; NONE
БББББББ
БББББББ
SOFTWARE
БББББББ
ББББББ Б
БББББББ
Baud Rate БББББББ
ББББББ Б
БББББББ
38400; 19200; 9600;
2400 БББББББ
ББББББ Б
БББББББ
38400
БББББББ
ББББББ Б
ББББББ Б
БББББББ
Copy
БББББББ
ББББББ Б
ББББББ Б
БББББББ
NO REPORT; SHORT
REPORT; LONG RE-
PORT
БББББББ
ББББББ Б
ББББББ Б
БББББББ
NO REPORT
БББББББ
БББББББ
Peak Reading Interval
(sec)
БББББББ
БББББББ
0, 1, 2, ..., 300 (seconds)
БББББББ
БББББББ
60
Flow Control. Scroll to the “Flow Control:” menu choice (by turning
the multi-function know) and then press the soft button that
corresponds to the appropriate type of flow control. If you do not
know which flow control is correct for your application, first try
HARDWARE when outputting a report to a printer, and SOFTWARE
when downloading a report to a personal computer.
Baud Rate. Scroll to the “Baud Rate:” menu choice and press the soft
button that corresponds to rate that is used by the receiving printer or
PC. For fastest data transfer when outputting a session report to a PC,
select the highest baud rate available in both the 764 and the PC;
then, if you experience difficulty with flow control between the 764
and the PC, set both to the next lower baud rate available and try
again.
Copy. The Copy submenu item determines the type of report that is
output when you press the Copy soft button (see Figure 23). When
NO REPORT is selected, the “Copy” function is removed from the
third soft button, and you cannot output a Session Report.