Toshiba KV-7960A - Manual (Page 43)

RECORDING OPERATION
PREPARATION
INTRODUCTION
PLAYBACK OPERATION
NOTICE
TIME DATE SEARCH
Searching a picture at a desired day and time is possible by specifying the day and hour on the MENU screen.
The VCR automatically records the current date and time (day/hour/minute). Accordingly, make sure before recording that the date
and time is exactly adjusted.
Search Operation
In case of searching the picture at day of 28, 17:30 minutes in
reverse direction;
1 Press the DISPLAY
button.
2 Press the SHIFT button
to blink TIME DATE
SEARCH and press the
SET button.
3 Press the SET button to
set the DAY to 28 and
press the
SHIFT
button.
4 Press the SET button to
set the HOUR to 17 and
press the
SHIFT
button.
5 Press the SET button to
set the MINUTE to 30.
6 Press the SHIFT button
to blink the REVERSE,
and press the SET
button.
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
DISPLAY TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
+ –
42
Note:
i Time date search is not carried out if the time adjustment has been not completed.
i Time date search is not carried out for tapes recorded by a unit which can’t automatically record data of time and date.
i Time date search will not operate when searching a section of tape that has an alarm on it. In this case perform alarm search.
i Time date search may cause a time error listed in the following to the specified time.
i Time date search may not be carried out in the areas at REC start and REC end shown below.
REC start REC end
less than
1min. less than A
Record mode
A2, A6, A12,
A18, A24, 24
48, 72
120
168
240
480
720
960
Time error to the
specified time at
maximum
1 min.
3 min.
4 min.
5 min.
7 min.
12 min.
18 min.
23 min.
A (Not carry out in
the REC end area
at maximum)
1 min.
3 min.
4 min.
5 min.
7 min.
12 min.
18 min.
23 min.
M E N U
CLOCK ADJUST
SETUP
SETUP
DISPLAY MODE
END=[DISPLAY]
PROGRAM
ALARM RECALL
TIME DATE SEARCH
FORWARD
MINUTE 00
REVERSE
TIME DATE SEARCH
DAY 1
MENU=[DISPLAY]
HOUR 0
FORWARD
MINUTE 00
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 0
FORWARD
MINUTE 00
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17
FORWARD
MINUTE 30
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17
FORWARD
MINUTE 30
REVERSE
TIME DATE SEARCH
DAY 28
MENU=[DISPLAY]
HOUR 17