Toshiba KV-7960A - Manual (Page 30)

NOTICE
PREPARATION
INTRODUCTION
RECORDING OPERATION
PLAYBACK OPERATION
If an alarm condition arises, the alarm function operates with an alarm input signal.
ALARM RECORDING
29
Operation at Alarm Input
When there is an alarm during recording, recording pause or stop modes, the VCR automatically goes into alarm recording mode.
The VCR can be programmed to record in the following time modes during alarm recording: A2, A6, A12, A18, A24.
A2, A6, A12, A18,
A24 hours
Recording
Recording pause
Stop Recording
Recording pause
Stop
Alarm input
Alarm Recording
i When there is an alarm input in the STOP mode, a slight delay will occur in start of the alarm recording.
i
When the pause mode continues for 10 minutes the VCR goes to the stop mode. This occurs in order to protect the video heads
and tape. While in pause mode, the video head is constantly tracing the same location.
i Alarm recording will not operate from power off mode and timer power off mode.
Event Recording
If event recording is desired, set the VCR’s recording mode to L01, L02 or L03. In order to accomplish this press the time mode
button until “L01”, “L02” or “L03” is shown.
If there is no alarm input present when in “L01”, “L02” or “L03” mode, the VCR automatically forwards 2 fields with recording every
appointed time (L01: 1min, L02: 2min, L03: 3min.) to protect the tape and the video head from damage.
Warning at Alarm Recording
When an alarm signal is input, the buzzer sounds and the alarm display on the VCR DISPLAY lights.
• At 1ST, the first (oldest) alarm input information is displayed.
• At AL1, the latest alarm input information is displayed.
• When more than seven items are input, the old information is erased and the new information is stored in the memory.
• To erase the alarm recall contents, press the ALARM button to change the counter display to alarm counter and press the
RESET button.
• Turn off the BUZZER switch to stop the buzzer.
• To stop the alarm display blinking, press the ALARM button to change the counter display to the alarm counter and then press
the RESET button.
Alarm Recall Display
Check the alarm input information on the ALARM RECALL screen.
The day of the week display
changes to the alarm number
during alarm recording.
Changes to a display of A2,
A6, A12, A18 or A24.
REC
ALARM
H
SP
Alarm display lights and then blinks when alarm recording is finished.
Changes to a display of A2, A6, A12, A18 or A24.
17:30:13 A 2
8/28/96 A01
M E N U
CLOCK ADJUST
SETUP
SETUP
DISPLAY MODE
END=[DISPLAY]
PROGRAM
ALARM RECALL
TIME DATE SEARCH
1ST 4/ 1/96MON 21:07:13
AL6 4/ 1/96MON 21:07:13
AL5 6/20/96THU 23:14:10
AL4 7/12/96FRI 19:14:12
AL3 7/25/96THU 0:14:12
AL7 --/--/----- --:--:--
ALARM RECALL
AL1 8/19/96MON 20:35:09
MENU=[DISPLAY]
AL2 8/ 7/96WED 21:35:16