Toshiba DVR620KU - Manual (Page 41)

41 EN 41 EN
Disc
Management
Recording
Playback
Introduction
Connections
Basic Setup
Editing
Function Setup
VCR Function
Others
Checking, canceling, or correcting the timer
programming information
If the timer program did not complete correctly,
the error number appears in the timer
programming list.
1) Press [TIMER SET].
2) Press [TIMER PROG.].
3) Check the information on the list you want to edit.
Timer Programming
1/1
THU JAN/01 10:00AM SP (1:00)
JAN/ 2/09 1:00 AM L1 SP
Date Start End L1/L2
JAN/02 1:00AM 2:00AM L1
New Program
4-A) To delete the timer program:
1 Use [K / L] to select the program you want to
delete, then press [ENTER].
2 Use [K / L] to select “Delete”, then press
[ENTER].
Selection menu will appear.
3 Use [K / L] to select “Yes”, then press [ENTER].
4-B) To correct the timer program:
1 Use [K / L] to select the program you want to
correct, then press [ENTER].
2 Use [K / L] to select “Program Change”, then
press [ENTER].
3 Correct the timer program by using
[K / L / { / B], then press [ENTER].
5) Press [TIMER PROG.] to exit.
6) Press [TIMER SET] to return to the timer standby
mode.
Timer Programming
1/1
THU JAN/01 10:00AM
Date Start End L1/L2
E41 JAN/02 1:00AM 2:00AM L1
New Program
Each error number means:
E1-22
E37-39 Recording error other
than below E40 Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
E23-24 Unrecordable disc
E25-28 Copy prohibited program
E29 Disc protected E41 Power failed
E30 Disc full E42 No disc when recording
E31-32 Already 99 titles
recorded
E43 Already 49 titles
recorded
E33 Already 999 chapters
recorded E44 Already 254 chapters
recorded
E34 No space for Control
information E45 Copy prohibited
program
E35 PCA full *1 E46 It is impossible to
record additionally
on a disc recorded
by other units
when setting
“Make Recording
Compatible” to “OFF”.
E36 Already finalized
video format disc
• A program with the error number is grayed in the timer
programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
*1 PCA is a disc's space reserved for recording test.
Note
• Press [TIMER PROG.] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted in red. In this case, you
cannot select any other program.
TIMER RECORDING
1) Press [STOP C] on the remote control.
Confirmation message will appear.
2) Select “Yes”, then press [ENTER].
• To stop the timer recording immediately, press
[STOP C] on the unit.
To stop the timer recording in progress
E9PKAUD_DVR620KU_EN.indd 41 E9PKAUD_DVR620KU_EN.indd 41 3/25/2009 3:47:53 PM 3/25/2009 3:47:53 PM