TANDBERG 6000 MXP - Manual (Page 25)

Installation
15
2.3 Monitor Configuration
Switch the system on by activating the power switch on the codec (located on the right hand side
at the rear of the codec). A green light is shown, located in the center on the front of the codec.
After the system has performed a self-test routine, the welcome menu will be displayed on the
monitor.
Monitor Configuration
Power on the monitor and use the monitor remote control to select the Audio/Video input used
(refer to your monitor manual). Remember to select S-video (S-VHS) input to avoid a black and
white picture.