TANDBERG 6000 MXP - Manual (Page 21)

Installation
11
2.1 Unpacking and Mounting
Unpacking the system
To avoid damage to the unit during transportation the system is delivered as separate
components:

Cabinet including DNAM speaker system

High quality monitor, one or two, depending on configuration. XGA monitors are optional.
Inside the cabinet you will find the accessories box, which will contain the following:

WAVE II Camera

Table Microphone

Remote Control and Tracker with batteries

Documentation
Mounting of the base

Place the top plate on top of the cabinet and secure it.

Place the monitor on the top plate.

Take the camera and remove the plastic backing from the double-sided tape-pads on the
base of the unit. Place the camera centrally, on top of the monitor close to the front. If the
system has two monitors, place the camera on the left monitor as this is where the
menus and incoming picture will be displayed.