TANDBERG 6000 MXP - Manual (Page 199)

Administrator Settings
189
4.8.7.1 IP Settings
Remember to restart the system after making changes to IP Settings. This can be done by
selecting the
“
Save and Restart
”
at the bottom of the IP setting menu. Changes in IP Settings
menu will not have any effect before the system is restarted.
IP-assignment
DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is present.
DHCP IP-address, IP-subnet mask and Gateway are not used because the DHCP server
assigns these parameters.
Static The system
’
s IP-address, IP-subnet mask and Gateway must be specified in the IP-
address field.
IP-address
IP-address defines the network address of the codec. This address is only used in static mode. In
DHCP-mode, the assigned IP-address can be found on the Welcome Menu.
IP-subnet mask
IP-subnet mask defines the type of network. This address is only used in static mode. Your LAN-
administrator will provide the correct value for this field.
Gateway
When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP
addresses, IP address, subnet mask, and default gateway must be specified by the LAN
administrator.
Ethernet Speed
Auto The codec will auto-detect the speed/duplex on the LAN.
10/Half The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full 10 Mbps speed/Full Duplex.
100/Half 100 Mbps speed/Half Duplex.
100/Full 100 Mbps speed/Full Duplex.
IP Access Password