Technicolor - Thomson 570 - Manual (Page 40)

3EC 17766 BAAA TCZZA Ed. 01
2 SpeedTouch™570 Web Interface
40
Wireless Click this button to display the SpeedTouch™570 Wireless page.
This page allows you to:
• View and/or supply the SpeedTouch™570 Wireless access point SSID and enable/
disable 64-bit/128-bit WEP encryption:
It is highly recommended that you configure a personalized SSID instead of the
default SSID. Enter an SSID of your choice and click Apply to apply the SSID.
By default no WEP encryption is activated. To activate it, select the desired WEP
encryption level (64-bit or 128-bit).
Enter a WEP key of your choice. In the case of 64-bit encryption, the 40-bits WEP
key must consist of 10 hexadecimal digits, in the case of 128-bit encryption, the
104-bits WEP key consists of 26 hexadecimal digits. Click Apply to apply the WEP
encryption settings.
To ensure the highest level of security, you should change the wireless settings on
a regular basis. However, never use obvious names and/or keys.
• View and/or configure some advanced SpeedTouch™570 Wireless access point
settings by clicking the Here link:
By default the SpeedTouch™570 Wireless access point uses automatic radio
channel selection to ensure maximum performance, communication speeds and
radio reaches. To specify a fixed channel, select one from the 'Channel' list and
click Apply.
By default only WLAN clients which are configured with the exact SSID, are
allowed to join the SpeedTouch™570 WLAN. You can change this setting to allow
also WLAN clients with a blank SSID, or SSID 'any' to join the SpeedTouch™570
WLAN.
You can enable/disable the registration button. In case the registration button is
disabled, the button must NOT be pressed to register a WLAN station.