TurboChef Technologies C3 User Manual
Page 23
M A I N T E N A N C E
P R O B L E M A R E A
O R F A U L T C O D E
P O S S I B L E C A U S E
(
S
)
S U G G E S T E D R E M E D Y
No power to oven
Oven not plugged in.
Main circuit breaker tripped.
Plug oven in.
Verify wall circuit breaker is on. Reset
breaker and then Power oven back on.
Oven does not
warm up
Oven is in off mode.
Door is not closed.
Oven has been switched off at the
main circuit breaker.
Cooking platter is not in the oven
correctly.
Press the “Oven On” Key.
Close the cook chamber door.
Turn the oven to OFF mode, leave for
2 minutes. Unplug the oven, leave for
2 minutes, re-plug, switch on isolator/Main
Supply & then switch on oven.
Place cooking platter in oven correctly.
Display Reads
“Oven Door Open”
and Alarm sounds.
Cook chamber door open.
Cooking platter not in oven correctly.
Platter is in oven correctly, but oven
reads “Oven Door Open.”
Open and close door several times.
Place cooking platter in oven correctly.
Check for food particles where platter sits
and around door.
Oven Does Not
Cook Properly
Oven is not clean. Large deposits
of grease, carbon or food debris will
dilute the microwave.
Incorrect Group and Item name
selected for the product or Incorrect
Cook Time selected for the product.
Product was not cooked at correct
programming temperature.
For example: frozen or chilled.
Wave Guide Cap or cooking
platter soaked or badly chipped.
Absorbed moisture or grease, apart
from cooking will seriously affect
the durability of the platter or
block the holes in the platter.
Clean the oven.
Check with the cook time sheet.
Ensure that the product was in the correct
state before being placed in the oven
Change the Wave Guide Cap and
cooking platter.
Change Cook Chamber Filter.
F1 Blower
Oven power interrupted
Verify wall circuit breaker is On. Reset
breaker and then Power oven back on. Place
the oven into “Oven Off” for 2 minutes,
disconnect the plug for minimum of 2 min-
utes, re-plug and press “Oven On” key.
19
The following is a list of all error fault/codes and possible problems that the oven may experience. Please attempt the
recommended action before calling for service.
T A B L E
1 : Error Codes/Faults, Possible Causes and Suggested Remedies