TurboChef Technologies C3 - Manual (Page 21)

17 M A I N T E N A N C E
C L E A N I N G
Carbon and grease buildup will adversely affect the
cooking performance and life expectancy of certain
components of the oven. It is the operator’s responsibility
to properly maintain this unit. Failure to maintain this
unit in a clean condition will void the warranty. For
cleaning supplies, please call Customer Service at
800.90TURBO or +1 214.379.6000.
WARNING: Use only TurboChef ® Oven
Cleaner and TurboChef ® Oven Guard. The use of
any other cleaning products can damage critical
parts and will void your warranty.
Supplies and Equipment
S U P P L I E S :
TurboChef ® Oven Cleaner - United States (103180)
TurboChef ® Oven Cleaner - International (103380)
TurboChef ® Oven Guard - United States (103181)
TurboChef ® Oven Guard - International (103381)
E Q U I P M E N T :
Nylon 3x5” green scrub pads
Dry, clean towels
Firm bristle brush: 6-8” handle with 2x2x1 bristles
x DO NOT use a nylon bristle brush. Nylon is
subject to melting.
Protective rubber gloves (optional)
Preparing the Oven for Cleaning
1. Place the oven in the OFF mode by pressing the BACK
key repeatedly until the OVEN OFF / COOLING DOWN
screen is displayed.
2. Open the oven door to expedite cooling
x
DO NOT clean the oven while blower is operating.
Daily Cleaning
Step 1: Prepare Oven
When oven is off and has cooled, remove ceramic cooking
platter (Figure 20).
x DO NOT remove the circular ceramic waveguide cap
during cleaning. It should remain in place throughout
the entire cleaning process.
CAUTION: Wait until oven is cool. Ceramics are
breakable, so handle with care.
Maintenance
To help your oven remain clean and in good condition, follow the daily and monthly cleaning instructions provided
in this section. Any unexpected issues you may encounter when using the C3 oven can often be resolved by referring to
the troubleshooting information in this section prior to contacting your service representative.
Step 2: Clean Internal Oven Surfaces
a. Remove cook chamber filter located on the rear-
left bottom corner inside of cook chamber and
clean.
b. Spray TurboChef ® Oven Cleaner on internal
surfaces and inner door of oven. Allow it to sit
five minutes before wiping with a damp cloth.
c. Remove stubborn stains with a non-metallic scrub
brush or pad.
d. Rinse surfaces with clean warm water and cloth
until cleaner is removed.
e. Wipe dry. Make sure to empty and clean grease
tray found behind vent in front of oven (Figure 20).
CAUTION: Do not leave standing water in the
bottom of chamber as recirculating water may
block the air passage.
Step 3: Clean Ceramic Cooking Platter
a. In a well ventilated area, spray ceramic cooking
platter with TurboChef
® Oven Cleaner.
b. Rinse with warm water and dry.
x DO NOT soak the platter in water or place in
dishwashing machine.
Step 4: Apply Oven Guard
a. Spray a thin layer of TurboChef ® Oven Guard on
all interior surfaces, including the ceramic wave
guide cap.
b. Install the clean ceramic cooking platter into the
oven - raised edge to the front of the chamber.
c. Turn the oven on and allow it to heat up to
temperature.
x
DO NOT spray Oven Guard on cooking platter.
CAUTION: Do not leave standing water in the
bottom of chamber as recirculating water may
block the air passage.
Monthly Cleaning - Exhaust Cover
(Figure 20)
On a monthly basis, apply the following steps:
1. Remove the exhaust cover from the back of the oven.
2. Clean the fan guard.
3. Reinstall the exhaust cover.