TurboChef Technologies C3 - Manual (Page 19)

15 O P E R A T I O N
F I G U R E 1 9 : Insert Smart Card
Loading a Menu from a Smart Card
Please note that once the procedure below is completed, the
old menu settings will be permanently lost .
1. Ensure the oven is in the OVEN OFF / COOLING
DOWN mode (page 12).
2. Enable the LOAD MENU function:
a. Simultaneously press the UP and DOWN keys.
b. Enter the code 6-3-6-8 (M-E-N-U) and press ENTER .
c. Press 9 to enable LOAD MENU .
3. Remove the lower access panel (Figure 19).
4. Insert smart card into oven (Figure 19).
5. Press the bottom-left soft key.
6. Select LOAD MENU FROM CARD . The menu on the smart
card will load to the oven.
7. When this process completes, the oven will beep.
Remove the smart card and reattach the lower access
panel.
Saving a Menu to a Smart Card
At some point you may be required to save your
existing menu settings to a smart card (for example, if the
control board needs to be replaced). Please note that once
the procedure below is completed,
any existing menu
settings on the smart card will be permanently lost .
1. Ensure the oven is in the OVEN OFF / COOLING
DOWN mode (page 12).
2. Enable the SAVE MENU function:
a. Simultaneously press the UP and DOWN keys.
b. Enter the code 6-3-6-8 (M-E-N-U) and press ENTER .
c. Press 9 to enable LOAD MENU . The oven will return
to OVEN OFF / COOLING DOWN .
d. Simultaneously press the UP and DOWN keys.
e. Enter the code 7-2-8-3 (S-A-V-E) and press ENTER .
The oven will return to the OVEN OFF / COOLING
DOWN screen.
3. Remove the lower access panel (Figure 19).
4. Insert smart card into oven (Figure 19).
5. Press the bottom-left soft key.
6. Select SAVE MENU TO CARD . The menu on the oven will
load to the smart card.
7. When this process completes, the oven will beep.
Remove the smart card and reattach the lower access
panel.