Tascam DA-302 - Manual (Page 17)

18
Section 6 : Playback
1
Set the COMMON MODE switch to OFF.
2
Press the PLAY key to start playback.
… When the REW key (F FWD key) is pressed during
playback, 2 times (3 times) normal speed rewind cueing
(fast-forward cueing) is performed. Pressing it once
more allows 4 times (6 times) normal speed cueing.
Pressing it once more restores 2 times (3 times) cueing.
To restore normal playback, press the PLAY key.
… Holding the REW key (F FWD key) pressed for 1 sec-
ond or more during playback performs 2 times (3 times)
normal speed rewind (fast forward) cueing for as long as
the key is pressed. Releasing it restores normal play-
back.
… Pressing the REW key during fast-forward cueing
switches to 2 times normal speed rewind cueing.
… Pressing the F FWD key during rewind cueing switches
to 3 times normal speed fast-forward cueing .
… Playback signals are output from the ANALOG OUT
and DIGITAL OUT connectors of Deck 1 (Deck 2).
6-1. Normal playback
With continuous playback, the tapes in Deck 1 and Deck
2 are played back continuously.
1
Set the COMMON MODE switch to "1 > 2".
2
Set "Seqtime" in the menu. ( úp.28)
3
Press the PLAY key on Deck 1 to start playback.
When the ABS time of Deck 1 reaches the time set
with "Seqtime", Deck 2 starts playback automatically.
4
Deck 1 automatically rewinds the tape to the beginning
either 3 minutes after the time set with "Seqtime" or
when the tape end is reached.
5
Deck 2 automatically rewinds the tape to the beginning
either 3 minutes after the time set with "Seqtime" or
when the tape end is reached.
… The playback signals are output from the ANALOG
OUT and DIGITAL OUT connectors of Deck 1
(Deck 2).
6-2. Continuous playback
When a Skip ID is detected during playback, the tape is
fast-forwarded to the next Start ID and resumes playback.
1
Select the deck with the SELECT 1/2 key.
2
Press the MENU key to show the following menu in
the time display.
Skip1 Off
3
Set to "On" with the UP/DOWN key to engage the
Skip Play mode.
… If the STANDBY key is set to ON, the Play-Pause mode
is engaged at the Start ID.
6-3. Skip playback
When a Start ID is detected during playback, this function
automatically engages the Play-Pause mode.
1
Select the deck with the SELECT 1/2 key.
2
Press the MENU key to show the following message in
the time display.
Single1 Off
3
Set to On" with the UP/DOWN key to engage the
Single Play mode.
6-4. Single playback
… The playback sound can also be monitored through the
ANALOG CASCADE OUTPUT connectors. When
"Cas Out" is set to "Auto" in the menu (
úp.28), play-
back sound output is switched from Deck 1 to Deck 2 at
the time Deck 2 starts playback. In this status, if the
PLAY key of Deck 1 is pressed, you can monitor the
playback sound of Deck 1 again.