Tascam DA-302 - Manual (Page 10)

11
Section 4 : Features and Controls
0 ID-related display
Shows the indication for the deck selected by the
SELECT 1/2 key.
START WRT:
Lights when the Start ID Manual Writing mode is
selected.
START ERASE:
Lights when Start ID erasing is selected.
SKIP WRT:
Lights when Skip ID writing is selected.
SKIP ERASE:
Lights when Skip ID erasing is selected.
END WRT:
Lights when End ID writing is selected.
RENUM:
Lights when renumbering is selected.
START:
Lights when the Start ID is detected.
SKIP:
Lights when the Skip ID is detected.
END:
Lights when the End ID is detected.
q Sampling frequency display
… When an analog signal is being recorded, the sam-
pling frequency (48.0k, 44.1k, 32.0k) selected by
the Fs switch is lit.
… When a digital signal is being recorded, the sam-
pling frequency (48.0k, 44.1k, 32.0k) of the input
signal is lit.
·When "DIGITAL" is selected with the INPUT
switch and recording is performed without dig-
ital signal input, 48.0k blinks.
… LP lights in the Long Play mode.
w Peak level meter
… Shows the input signal level during
recording/record-pause/sampling monitor.
… The playback signal level is shown during play-
back.
… When the input or playback signal level surpasses
the full-scale level, the OVER section lights.
e Time-related display
ABS:
Lights when the ABS time is shown on the time
display.
PGM:
Lights when the PGM time is shown on the time
display.
REMAIN:
Lights when the REMAIN time is shown on the
time display.
r Repeat display
Shows the indication for the deck selected by the
SELECT 1/2 key.
REPEAT:
Lights in the One-Program Repeat mode.
ALL REPEAT:
Lights in the All-Program Repeat mode.
8
COMMON MODE switch
1 & 2:
Select to engage both Deck 1 and Deck 2 in the
Record or Play mode at the same time.
1 ∑ 2:
Continuous playback or recording on Deck 1 and
Deck 2.
OFF:
For independent operation of Deck 1 and Deck 2.
9 Fs switch
… When recording analog input signals, select the
sampling frequency (32k, 44.1k, 48k).
·When 32k is selected, the Long Play mode is
engaged.
·When recording digital input signals, the sam-
pling frequency is automatically determined
according to the input signals.
0 MARGIN RESET key
… Resets the margin value when pressed while the
margin value is shown in the program number/mar-
gin display.
·When holding this key pressed, the margin value
corresponding to each input signal is shown con-
tinuously.
… Shows the margin value for as long as it is pressed,
when pressed while the program number is shown
in the program number/margin display during play-
back.
q INPUT level controls
Use to adjust the recording level.
w SELECT 1/2 key
To select the control deck for Deck 1 and Deck 2 (ID
MODE key, EXECUTE key).
When setting the menu, use to select the deck as
required.
e ANALOG INPUT switch
Set this switch when input signals are analog.
UNCAL:
To adjust the recording level with the INPUT level
controls.
CAL:
The input and output levels are fixed and the record-
ing level cannot be adjusted.
·For the specified input level, the level meter shows
-16 dB.
r INPUT switch
Set this switch according to input signals.
ANALOG:
Select when input signals are analog.
DIGITAL:
Select when input signals are digital.