beautypg.com

Parameter setting functions – Toshiba B-880-QQ SERIES User Manual

Page 11

background image

Parameter Setting Mode Table

Function

Baud rate of the serial interface is selected.
Data length of the serial interface is selected.
Stop bit of the serial interface is selected.
Parity of the serial interface is selected.
Transmission control mode of the serial interface is selected.
Language which displays LCD message is selected.
Auto forward wait in cut mode is selected. When idle for 3 seconds or
more after cutting, the printer automatically feeds the paper 10mm
forward.
Print head up in cut mode is selected. If a back feed is performed when
this parameter is ON, it is done while the print head is up. (Available
only when the ribbon saving module is installed and the ribbon save
mode is ON.)
The ribbon saving module is selected. Be sure to set this parameter to
ON when using the ribbon saving module.
The command code out of AUTO, ESC/LF/NUL, or { I } is selected.
Ribbon type either transmissive or non-transmissive is selected.

The media sensor position is selected.

CENTER: Fixed
EDGE:

Movable

Mode Name

SPEED
DATA LENG.
STOP BIT
PARITY
XON+READY
LCD
FORWARD WAIT

HEAD UP CUT

RIBBON SAVE

CODE
RIBBON
SENS POSI

4. PARAMETER SETTING FUNCTIONS

4. PARAMETER SETTING FUNCTIONS

4. DIP SWITCH FUNCTIONS

4-1

EO1-33017

The Following table illustrates settings that are selected only by changing the Printer's PARAMETER
settings. This procedure can be found in the Maintenance Manual section of the B-880 Series SERVICE
MANUAL under section 6.3. Please Contact your authorized TOSHIBA TEC representative to change the
operation panel settings.