TechniSat DigiCorder S2 - Manual (Page 37)

7.15.1 Acquiring (downloading) SFI data
The programme information will be updated automatically by
your receiver at the pre-selected updating time (Point 9.2.2),
provided the receiver is in stand-by mode at the time.
The downloading procedure will be indicated by the message
Load SFI appearing in the display. If your receiver is swit-
ched on at this time, the function will not be executed.
You can also, immediately after switching off the receiver
(while the display shows the message Load SFI?) press the
SFI key to start the downloading procedure manually. While
the download is in progress, the display will show Loading
SFI, as well as the percentage of SFI data downloaded so
far (e.g. 38%).
The duration of the downloading procedure depends on the
number of programmes included. Previews can extend as far
as seven days in advance. As more programmes are added
to the electronic programme guide, the volume of data incre-
ases, and the preview period is reduced correspondingly.
It is up to you to decide which programmes should be listed
in the electronic programme guide. These can be selected as
described in Points 9.2.5 and 9.2.6.
7.15.2 Interrupting the download procedure
The downloading procedure can be interrupted by switching
on the digital receiver (On/Stand-by key). The SFI data of
the previous update are then available.
7.15.3 Calling up the Electronic Programme Guide
> Presss the SFI key on the remote control of the digital
receiver.
The electronic programme guide will now be displayed
on screen (Fig. 7-17). If you have selected the starting
category Overview (Point 9.2.3), the channels you
have selected, or those of the factory default settings,
will be shown with their current programmes (see also
Point 9.2). You can now use the SFI functions to
obtain information on the contents of the various pro-
grammes.
In addition, you can use the SFI functions to switch to
a particular programme, to mark it, or to activate it in
the timer programming function.
37
(Fig. 7-17)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 37