Texas Memory Systems RamSan-500 - Manual (Page 20)

RamSan-500 User’s Manual 20 of 48
MAC address. Use this value to
configure your DHCP server.
Set IP Config
DHCP
Re-enter the “Network Config”
menu, then “Set IP Config”
menu and select “DHCP”.
Use DHCP for IP?
↓ Yes ↑ No
The next screen commits the
changes and automatically
restarts the network.
Restarting
Network... Done You should witness the network
restarting.
New IP Address:
192.168.111.58
The final screen displays the IP
address assigned by the DHCP
server.
If the network fails to start, check the Ethernet connection and contact
your system administrator. If the system successfully saved the IP
configuration, you may simply select the “Restart Network” option from
the “Ethernet Setup” menu instead of re-selecting the same IP
configuration.
4.6 Additional System Management Options
4.6.1 4.6.1 4.6.1 4.6.1 Connecting using a Connecting using a Connecting using a Connecting using a T T T Terminal erminal erminal erminal P P P Program rogram rogram rogram
To connect to the RamSan-500 using a serial port connection, use
a dumb terminal or a terminal emulation program such as
Windows™ HyperTerminal. Set your baud rate to 9600 with 8 data
bits, 1 stop bit, no parity, and no flow control. Connect to the serial
port using a DB-9 non-null serial cable.