Toshiba CS3950D - Manual (Page 6)

v
D4133738B
OTHER INSTRUCTIONS
Do NOT use power other than specified
Be sure to use DC12V power supply. The camera is designed to work only under the specified voltage.
Do NOT attempt to drive the camera with the power other than DC12V. Operating the camera under
power other than DC12V invites a fire or an electric shock hazard.
Avoid intensive light
Do NOT expose the camera’s image-pickup-plane to sunlight or other intense light directly. If the part
of CCD is exposed to spot-intensive light, you might get a picture problem like blooming and/or smear.
Under the comparison at the same video output level, the faster the electronic shutter speed setting, the
more smear is generated.
Use under right operation condition
This equipment is designed and guaranteed to work under the temperature range of 0 to 40 degrees C
and 30 through 90% humidity range. Avoid using the equipment beyond that limits.
Handle with care
Take care not to drop the equipment, nor give strong impact, as this may cause breakdown.
Do NOT tamper with switches
Read this operation guide thoroughly before you touch switches and adjusters on the rear panel.
Do NEVER attempt to disassemble the camera and/or tamper with any inner switches, potentiometers,
etc.
Avoid liquid
Avoid placing the camera where it is likely to be splashed with water or any other fluids. Operating
the camera with its inner parts/circuits in an wet condition might cause a damage or an electric shock
accident.
Avoid placing near TV/radio
This camera might cause an interference (e.g. noise) if used around radio / TV set. In such a case,
change the location of your camera (or radio / TV).
Abnormal operation
In the event that any abnormal condition is observed, turn the power switch OFF immediately. Do
NOT try to continue to use the camera. To do so reckless of visible signs of malfunction invites a fire,
an electric shock hazard, or any other serious damage to the camera. In such case, contact us or our
dealer/distributor from which you purchased the camera for repair service.
Camera installation
For mounting this camera, use screws having inner depth (the portion which go inside the camera
chassis side) shorter than 3.5mm for M3.0, 4 places or 3.0mm for M2.0, 4 places. Longer screws
contact and might damage inner boards/parts.
Waste treatment
Wastes of this product should be separated and discarded in compliance with the various national and
local ordinances.