Toshiba CS3950D - Manual (Page 10)

4
D4133738B
Exposure time delay under RTS
When the RTS is active, both in FIX mode and PULSE W mode, there is a time delay of
approximately 1.4 micro s until the start of exposure after the rising edge of TRIG signal
(positive).
Exposure time under pulse width mode
Under RTS pulse mode, the exposure time is determined by the pulse width. More exactly,
the actual time is the pulse width plus approximately 8.0 micro s.
(4-3) Restart / Reset
The restart / reset function is available with the ext.VD signal. You can get an arbitrary
slower shutter speed than normal shutter and random trigger shutter.
Here are some notes;
*
The shutter speed (exposure time) is determined by ext. VD signal interval.
** This function is enabled when the rear-panel shutter speed DIP SW is OFF.
*** Supply consecutive HD.
VD,V-SYNC output for 1V only
VD,V-SYNC pause during standby
TRIG IN
(Positive)
VIDEO OUT
CCD Exposure
WEN OUT
(Standard)
TRIG IN not acceptable for
1V after mode chenge
Exposure time
(E-shutter speed or
pulse width)
Definite
Automatically returns to normal shutter
if fixed H level (after approx. 1/6s)
Normal shutter Random trigger shutter Normal shutter
Exposure time = Pulse width + Approx. 8.0 micro s
CCD
Exposure
TRIG IN
Exposure delay time = Approximately 1.4 micro s
Pulse width
VIDEO OUT
CCD Exposure
EXT VD IN
WEN OUT
(Standard)
WEN OUT
[Option]
The exposure time is
determined by VD interval