Toshiba CS3950D User Manual
Page 11
5
D4133738B
(5) Partial-scan mode selection (Camera rear-panel DIP SW)
Switches partial-scan mode
Note: Sometimes phenomenon called as “whiteout” occurs at the top of the screen when
there is strong incident light entering in the wide area of a CCD, however, this is not
a malfunction. If this occurs, reduce the amount of incoming rays.
(5-1)1/2 Partial-scan --- Screen center 1/2 readout
Only the center portion of 344H out of the total effective lines 768H (excluding BLK
time) is read out. Available both under external / internal mode.
■Under normal shutter (Electronic shutter OFF)
Notes: * Under ext. sync, the ext. VD should be 1V = 387H.
** Under normal shutter, set the rear-panel DIP SW #5, #6 in OFF.
■Under other shutter modes
212H
212H
High-speed
transfer
Normal-
speed
transfer
High-speed
transfer
344H
344H
Normal-
speed
transfer
28H
344H
VIDEO OUT
VIDEO output
time
15H
213
High-
speed
transfer
556
213
556
V BLK
(Include
High-speed
transfer)
387H
387H
9H
WEN OUT
(Standard)
9H
9H
28H
344H
*1
15H
213
(409H)
556
9H
*2
VIDEO OUT
WEN OUT
(Standard)
V BLK
(Include
High-speed
transfer)
VIDEO output
time
High-
speed
transfer
*1:Arbitrary under ext.sync
*2:See "7.TIMING CHART (4)WEN timing".
9H