Toshiba CS3950D - Manual (Page 14)

8
D4133738B
[Shutter trigger spec] Exposure-starting-cue signal in random trigger shutter mode
(1) Input level LOW level: From 0 through 0.5V
HIGH level: From 4 through 5V
(2) Input impedance High impedance (10k-ohm)
(3) Capture timing Rising edge detection (Positive) / Falling edge detection (Negative)
(Switching via rear-panel DIP SW)
(Initial factory setting: Rising edge)
(4) Pulse width Minimum 2 micro s
Maximum 1/8s
[Sync signal spec]
(1) Readout signal WEN readout timing pulse
(2) Polarity Negative
(3) Pulse width 1H output
(4) Output circuit
[Electronic shutter spec]
(1)Normal shutter Shutter-speed setting via rear-panel SW (Initial: OFF)
12 steps switch-able (= OFF, 1/60s, 1/125s, 1/250s, 1/500s, 1/1000s,
1/2000s, 1/5000s,1/10000,1/20000,1/50000,1/100000)
(2)RTS
(a)Operation mode
Notes : * RTS mode automatically switches over through TRIG IN
**RTS disabled under Electronic shutter OFF
(b)Multiple shutter Multiple shutter via ext. trigger signal and ext. VD signal
Notes : * Operation like No.3, 6 above
WEN OUT
100 50
WEN
2SC3734
2SA1461
5
V
No. Reset Exposure Sync
1 Internal
2 Consecutive HD / Consecutive VD IN
3 Consecutive HD / Single VD IN
4 Internal
5 Consecutive HD / Consecutive VD IN
6 Consecutive HD / Single VD IN
7 Internal
8 Consecutive HD IN
9 Internal
10 Consecutive HD IN
TRIG pulse width
(PULSE width mode)
V-reset
Rear SW
(FIX mode)
Non-reset
Rear SW
(FIX mode)
TRIG pulse width
(PULSE width mode)