Tripp Lite UT2012UL User Manual

Page 2

Set of 4 dip switches support wet/gel/AGM battery charging profiles, adjustable 135/145V high voltages and selectable 75/85/95/105V AC

low voltage auto transfer during brownouts

Set of 4 additional dip switches support 4 levels of charger limiting relative to output load size, a battery equalization program and battery

charger low/high settings

Resettable 25A charger AC input breaker and settable 20A AC output breaker and automatic 2-speed cooling fan

Automatic overload and thermal (overheating) shutoff

Front panel remote control connector enables remote off/on switching with included APSRM4 remote

Load sensing control dial enables adjustable load threshold required to automatically turn the inverter on and off in DC mode as load

conditions change

Includes a battery temperature sensor with 20 foot cable to prolong battery life by adjusting the charge level based on battery temperature

Specifications

OVERVIEW

Intended Application

Utility/Long Haul Truck, Emergency Home Power

OUTPUT

Frequency
compatibility

60 Hz

Output watts

2000

Continuous output
capacity (watts)

2000

Output nominal
voltage

120V

Output voltage
regulation

LINE POWER (AC): Maintains 120V nominal sine wave output from line Source. Inverter Power (AC) Maintains PWM
sine wave output voltage of 120 VAC (+/- 5%)

Output frequency
regulation

60 Hz (+/- 0.3Hz)

Overload protection

Includes 25A input breaker dedicated to the charging system and 20A output breaker for AC output loads

Outlet quantity / type

2 AC outlets

Outlet details

2 NEMA 5-15R GFCI protected outlets

INPUT

Nominal Input
Voltage(s) Supported

120V AC

Recommended
Electrical Service

DC INPUT: Requires 12VDC input source capable of delivering 192A for the required Duration (when used at full
continuous capacity- DC requirements increase during Over-Power and Double-Boost operation). AC INPUT: 15A
120VAC recommended.

Input connection type

DC INPUT: set of two (2) DC bolt-down terminals. AC INPUT: NEMA 5-15R GFCI input plug

Input cord length
details

DC INPUT: User supplies cabling. 6 gauge or larger (see manual) AC INPUT: attached 6ft. AC line cord with plug

Voltage compatibility
(VAC)

120

Voltage compatibility
(VDC)

BATTERY

Expandable battery
runtime

Runtime is expandable with any number of user supplied wet or gel or AGM type batteries

DC system voltage
(VDC)