Topcom BUTLER 3500 User Manual

Page 18

Topcom Butler B3500/3501/Twin

6.2 REMOVING A HANDSET

You can remove a handset with a base to allow another handset to be registered
1.

Enter the menu by pressing

/OK

Select SETUP using the up

and down

keys

Press OK

Select DEL HANDSET using the up

and down

keys

Press OK

Enter the 4 digit base PIN code

Press OK

Select the handset to be removed

Press OK to validate

6.3 SETTING UP A HANDSET ON ANOTHER BASE

If you want to use a Butler 350x handset with a base of another model. The base must be GAP compatible.
1.

To put the base in registration mode, refer to the base user manual.

Carry out operations 3 to 10 from the paragraph 6.1.

6.4 SELECTING A BASE

The handsets can be registered up to 4 bases simultaneously.
To select a base:
1.

Enter the menu by pressing

/OK

Select REGISTER using the up

and down

keys

Press OK

Select SELECT BASE using the up

and down

keys

Press OK

Select a base or select AUTO using the up

and down

keys

Press OK

When selecting the base, the currect selected base in indicated by a blinking base number. If you select ‘Auto’ the
handset will automatically search for another base when you are out of range!

6.5 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET

Make sure that the base pin-code is set to ‘0000’! See 4.6 for changing the base pin-code.
Press and hold the paging key

of the base for 6 seconds.

The base will then emit a beeptone. The line/charge indicator

will blink quickly for one minute. During this minute,

the base unit is in subscribing mode and you must do the following to subscribe the headset:

Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.

Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.

Press the headset registration key. The red LED will flash rapidly.
-

If after a few seconds the green LED flashes slowly, the registration is successful.

If the red LED flashes slowly, the registration is failed. Repeat above procedure and make
sure that the base pin-code is set to ‘0000’!

DECT GAP Profile only guarentees that basic calling-functions will work correctly between different
brands/types. There’s a possibility that certain services (like CLIP) will not work correctly.

B3500.book Page 18 Friday, December 19, 2003 10:08 AM