Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 44)

ASSEMBLY
Assembly Section 2-18
DRAFT BEAM INSTALLATION
Install ½” O-ring breather into butt port of inboard cylinder. Install fittings in the rod end of the
cylinder according to the diagram in the Common Parts section. These fittings should be
positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder and lock
into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the pin, flat-washer
and R-clip as shown below.
Install all fittings in the outboard cylinder and adjust to point towards the butt end of the
cylinder. Attach the hoses as specified in the parts book. Slide the cylinder into the draft beam
from the outside of the draft beam and attach cylinder to the draft beam with clevis pin and
rollpins.
(ASM-C-0076)
DRAFT BEAM MOUNTING
Pull the inboard cylinder poston rod down to the extreme extended position. Slide the draft
beam under the cylinder
Using inboard cylinder as a pivot point, slide draft beam under tractor and install draft beam
pin. Align hole in draft beam pin with holes in main frame boss and install cap-screw and nylock
nut.
(ASM-C-0078)