TANDBERG T2000 MXP - Manual (Page 208)

D1337703_T2000_MXP_User_Manual
198
5.3 DVD / VCR
DVD/VCR Playback
Mono
For playback, connect a cable between Video Out on the VCR and Video In (VCR) on the
system. Connect a cable between Audio Out on the VCR and the Audio In (VCR) on the system.
Choose VCR from the Presentation menu to activate the VCR input.
Make sure that Audio In (VCR) is On (see chapter
Audio ). If audio from VCR is too low, this level
can be adjusted in Audio Settings, Inputs, Level Settings. The audio from the VCR will be audible
in the local speaker system.
The audio from the VCR and your microphone(s) will be mixed and sent to the far end. When a
person talks on either local or far end, the VCR audio level will be reduced to make it easier to
comment on a video recording when Audio Settings, VCR Ducking: On.
Stereo
For stereo playback, connect:

Video cable between Video Out on the VCR and Video In (VCR) on the system

Audio cable between Audio Out (L) on the VCR/DVD and the VCR L (Audio In 3)

Audio cable between Audio Out (R) on the VCR/DVD and VCR R (Audio In 4)

Choose the VCR video source (se chapter Presentation menu ) to automatically
activate the VCR audio and video input.
Make sure that:

Stereo Input Mode is set to On (see chapter Stereo Settings )

128 AAC-LD is enabled (see chapter AAC-LD 128 kbps )

AAC-LD is enabled (see chapter Audio Algorithm )

Audio In (VCR) is On (see chapter Audio ). If audio from VCR is too low, this level can be
adjusted in Audio Settings, Inputs, Level Settings. The audio from the VCR will be audible
in the local speaker system.

To enable VCR/DVD ducking (reduce volume when speaking), check that VCR Ducking
under Audio Settings is set to On.
Note that the audio from the VCR/DVD and your microphone(s) will be mixed and sent to the far
end. When a person talks on either local or far end, the VCR/DVD audio level will automatically
be reduced to make it easier to comment on a video recording when Audio Settings, VCR
Ducking: On.
Note that a system with one video output and one mixed (local and far end) audio output is
required for recording. For playback, a system with one video input and one audio input
without integrated echo cancellation is required.