TANDBERG T2000 MXP - Manual (Page 204)

D1337703_T2000_MXP_User_Manual
194
C1 Analog Red C2 Analog Green C3 Analog Blue
C4 Analog
Horizontal
Sync C5 Analog Ground
(analog, R, G &
B return)
5.1.2 Audio
4 Audio Inputs

2 microphone inputs (balanced, 24V phantom powered) via XLR connectors.

2 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to chapter
Audio .
Audio input connector specification:
Connector label Microphone(s) Audio input(s)
Signal type Balanced Unbalanced
Connector (codec) XLR-F, pin 1-gnd,
pin 2 hot, pin 3-
cold/neutral Female RCA/phono,
sleeve-ground,
centre-signal
Input impedance 2400 ohms (pin 2 -
3) 10K ohms
Max input level when
set to maximum
input level 83 mVpp 15.5 Vpp
Max input level when
set to minimum input
level 6.2 mVpp 1.17 Vpp
Range, menu
adjustable input gain 22.5 dB (16 steps of
1.5 dB) 22.5 dB (16 steps of
1.5 dB)
Phantom power
voltage 24 V +/- 5% -
Phantom power
resistor, pin 2 1200 ohms -
Phantom power
resistor, pin 3 1200 ohms -
Max phantom power
current pr mic 12 mA
-
2 Audio Outputs

2 outputs (line level) via RCA connector providing audio from far end in addition to dial
tones. These outputs are used by the monitor loudspeakers.