Toshiba IK-WB16A-W - Manual (Page 10)

10
NOTES ON USE AND INSTALLATION
l Do not aim the camera at the sun
Never aim the camera at the sun even with the camera power off.
l Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe
may appear on the screen. However, this is not a malfunction.
l Treat the camera with care
Dropping or subjecting the camera to intense vibration may cause it to
malfunction.
l Avoid Volatile Liquid
Do not use volatile liquids, such as an insect spray, near the unit. Do not leave
rubber or plastic products touching the unit for a long time. They will leave
marks on the finish. Do not use a chemically saturated cloth.
l Never touch internal parts
Do not touch the internal parts of the camera other than the parts specified.
l Keep the camera installation away from video noise
If cables are wired near electric lighting wires or a TV set, noise may appear in
images. In this event relocate cables or reinstall equipment.
l Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than the
specified operating range. Doing so could affect the internal parts or cause the
image quality to deteriorate. Special care is required to use the camera at high
temperature and humidity.
l Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power and
contact your dealer. If you continue to use the camera when there is something
wrong with it, the trouble may get worse and an unpredictable problem may
occur.