Tascam DA-78HR - Manual (Page 25)

4 - Menu interface, etc.
25
TASCAM DA-78HR
4.8 TC chase menu
TC. CHS --
The following parameters are
used to control the DA-78HR operations when chas-
ing to an incoming timecode signal:
4.9 TC generator menu
TCG. REC--
The following parameters are
used to control the internal timecode generator.
4.10MIDI menu
MIDI--
The following parameters are used
to control the MIDI parameters of the DA-78HR.
Display
Values
(*=default)
Described in
INDiv. REC
(individual record-
ing)
0 * (off), 1 (on) 9.6.11, “Individual
recording while
chasing timecode”
Enabling individual recording while chasing
RECHS. MD
(rechase mode)
RECHASE *
(rechase), FREE
(free)
9.6.9, “Rechasing
timecode”
Rechase mode
RECHS. WD
(rechase window)
1 SEC *, 2 SEC (1
or 2 seconds)
9.6.9, “Rechasing
timecode”
Width of rechase “window”
ERR. BYPAS
(error bypass)
10 FRM *, 30 FRM
(10 or 30 frames)
9.6.10, “Bypassing
timecode errors”
Length of time for error bypass when chasing
PK. POS . TST
(park position
test)
OFF *, ON 9.6.6, “Park posi-
tion”
Performs the park position test
PARK. POS.
(park position)
00 00 * (0 sec-
onds, 0 frames) to
01 29 (1 second,
29 frames)
9.6.7, “Automatic
park position set-
ting”
Park position timing
Display
Values
(*=default)
Described in
TC. REC. SRC
(TC recording
source)
EXT * (external),
TCG (TC genera-
tor), TAPE TC
(tape timecode)
9.5.1, “Selecting
the timecode
source”
Selects the source of the timecode “stripe”
TC. REC. EN
(TC recording
enable)
0 * (off), 1 (on) 9.5.2, “Recording
timecode using the
generator”
Enabling of timecode recording
STRT. Time
(TC generator)
Time value in
hh:mm:ss.ff
(00:00:00.00*) 9.5.2, “Recording
timecode using the
generator”
Start time for on-board generator
TCG. MODE
(TC generator
mode)
reset * (reset),
CoNT (continue)
9.5.3, “Generator
modes”
Restart mode for on-board generator
TCG .
(TC generator)
stop * (stop),
run (run)
9.5.2, “Recording
timecode using the
generator”
Start/stop timecode generator
Display
Values
(*=default)
Described in
MIDI
(MIDI)
on *, off 10.1, “MMC enable
and disable”
Enables or disables MIDI (including MTC)
ID
(MIDI ID)
ALL *, 1 to 1 27 10.1.1, “Assigning
a MIDI ID to the
DA-78HR”
MMC ID
MTC
(MTC)
ON *, OFF 9.4.4, “MTC output”
MTC output
FAST. MTC
(fast MTC)
on *, off 9.4.4, “MTC output”
MTC output in fast wind mode
STOP. MTC
(stop MTC)
on *, off 9.4.4, “MTC output”
MTC output in stop mode
Display
Values
(*=default)
Described in