beautypg.com

Wireless remote control, Before installation – Toshiba CARRIER RAV-SP420CT-UL User Manual

Page 7

background image

– 6 –

Under Ceiling Type

Installation Manual

EN

Toshiba

„

Wireless remote control

Decide the position which remote control is operated
and the installation place.
And then refer to the Installation Manual of the wireless
remote controller kit sold separately.
(The signal of the wireless type remote control can be
received within approx. 23’ (7 m). This distance is a
criterion and varies a little according to capacity of the
battery, etc.)
• To prevent malfunction, select a place where is not

affected by a fluorescent lamp or direct sunlight.

• Two or more (up to 6 units) wireless-type indoor units

can be set in a room.

„

Before installation

1

Removal of suction grille

Slide the suction grille fixing knobs (2 positions)
toward the arrow direction, and then open the
suction grille.
Under the condition of suction grille opened, push
the hook section of hinges (2 positions) at the rear
side, and then pull out the suction grille.

2

Removing wire guard

Remove the screws (2 pcs.) which are fixing the
wire guard.
Remove the clamp fixing screws and remove the
wire guard.

CAUTION

Attach back the wire guard once indoor unit is installed.
Remove the 2 screws fixing the wire guard and hung the
wire guard with the clamps during a service.

Ap

pro

x. 2

3’ (

7 m

)

Pull out suction grille

while pushing hook.

Suction grille

fixing knob

Suction grille

Hinge

Slid

e

Clamps

Screw

Wire guard

6-EN

+00EH99864801_00Ta.book Page 6 Tuesday, November 24, 2009 5:40 PM