Tripp Lite NetCommander B072-008-1 - Manual (Page 21)

21
Verifying the Server Interface Unit's version number
Before you can check a Server Interface Unit, you must uncheck the Switch Unit box
options.
To verify the Server Interface Unit version number:
1. Open the KVM Switch Update program.
2. Check one or more or all of the Server Interface Units.
3. Click
. The firmware version number appears after the Server Interface
Unit number.
4. Click
. The hardware version number appears after the Server Interface
Unit number.
When “Not responding” appears, no computer is connected, or it is switched off.
Software
(continued)
Download the latest firmware for your system from www.tripplite.com
Obtaining New Firmware
Warning! Never switch off any computer connected to the KVM system during the
Firmware Upgrade process.
1. Download the latest firmware for your B070-016-19 KVM Switch from
www.tripplite.com
2. Using the Update Computer, open up the Firmware Upgrade Software
3. In the KVM Switch Update Window, select the KVM Switch, KVM Switch OSD or
SIU(s) you would like to upgrade
4. From the File Menu, choose Open to open up the firmware upgrade file you down
loaded from www.tripplite.com and open the file
5. Click the Start button to begin the update. When finished, the firmware version number
will appear next to the unit you just updated
6. Check to make sure the Firmware Version Number is correct by following the steps on
page 20-21. If it does not show up as the most current Firmware Version Number, start
the upgrade over again.
Updating the Firmware
Figure 18 The Open box