Tripp Lite NetCommander B072-008-1 - Manual (Page 18)

18
Operation
(continued)
Moving the Label (F6)
You can position the OSD label anywhere on the screen.
To position the label from the Main window:
1. Move to the desired computer using the Up and Down Arrow keys.
2. Press the [F6] key. The selected screen image and Identification label are displayed.
3. Use the arrow keys to move the label to the desired position.
4. Press [Esc] to save and exit.
Software
With the NetCommander KVM Update software program you can upgrade the firmware for
the:
• OSD
• B070-016-19 Console KVM
• Server Interface Units
KVM Update enables you to add new features and take advantage of product improvements
in a quick and efficient manner.
Upgrading the KVM Firmware
• Pentium 166 or higher with 16MB RAM and 10MB free Hard Drive space
• Free Serial port
• Windows 2000 and later
• To update the firmware the KVM system must be connected and switched on.
System Requirements for Firmware Upgrade
Tuning (F5)
You can tune the image of any remote computer screen.
To adjust the screen image:
1. In the OSD Main Menu highlight the computer you want to adjust.
2. Press the [F5] key. The screen image of the selected computer is displayed, along with
the Image Tuning label.
3. Adjust the image by using the Right and Left Arrow keys.
4. When the image is satisfactory, press [Esc].
Note! Distance affects picture quality. The further away a remote computer is from the
KVM, the lower the image quality and the more tuning needed. Therefore put any
higher resolution computers closer to the KVM.