Technicolor - Thomson DGE505N - Manual (Page 16)

Chapter 3: Playing Discs
14 Graphics contained within this publication are for representation only. Your unit might differ slightly.
To Load and Play a DVD Disc
Turn on the TV and your DVD Player (press ON•OFF on the remote or press the STANDBY/ON button on the remote
control).
1. If necessary, tune the TV to its Video Input channel (if you need more information, go to page 54).
2. Press the OPEN•CLOSE button (the disc tray opens).
3. Place a disc gently into the tray with the disc’s label facing up (double-sided discs have content on both sides, so
you can place either side up).
4. Press the OPEN•CLOSE or PLAY button. The disc tray closes. The DVD Player reads the disc’s table of contents,
and then one of three things happens depending on how the disc was programmed:
• The disc starts playing.
• The disc menu appears on the screen. One of the options will start disc play. Highlight that option and press
OK.
• The DVD Player’s main menu appears on the screen. Highlight the Play option and press OK.
When you stop playing a disc, the player remembers where you stopped. When you start playing the disc again, the
DVD Player picks up where you left off unless the disc is removed or the player is unplugged, or if you press the STOP
button twice.
C an
't Catch Up
C an
't Catch U
p
Can 't C at ch Up (Widescreen Ve rs io n)
This is an example of a two-
sided disc — the title is usually
in the center of the disc.
This is an example of a one-
sided disc.
15909540 FINAL 7/25/02 8:11 AM Page 14