Technicolor - Thomson Thomson Scenium DPL4000 - Manual (Page 23)

20
Advanced Sound Control
Stereo
The Stereo mode uses the two main channel outputs
from the front speakers. Use this mode if you have
connected the front speakers only.
DSP (Digital Sound Processor)
These digital sound effects resemble sounds in a real
environment such as (DSP OFF / STADIUM / CONCERT /
THEATRE / CHURCH / ARENA / CLUB). DSP automati-
cally converts analog audio signals to digital ones
which enables you to adjust the sound without
degrading the sound quality. Different modes will
give you different feel of size and type of listening
environment. Press DSP MODE on the main unit to
select among DSP options.(Not available in Dolby
Digital/DTS).
Night Mode
By using Dynamic Range Compression technology
(Night Mode), you can enjoy enhanced Dolby Digital
sound quality at night without interrupting your
roommates or neighbors. Night Mode will compress
the difference in volume between normal voices and
sound like explosions, while still enjoying a Dolby
Digital enable component (DVD, SAT). You can access
the setup menu by pressing SETUP. Then press the
Up or Down setup arrows until NIGHT is displayed.
Press OK to enter Night setup. Use the Up or Down
setup arrows to select among compression options
(NORMAL, SOFT and SOFTER). Press OK to save set-
ting.
EQ Mode
Sound can be adjusted to resemble various music
types. Bass and treble levels vary between the differ-
ent music styles. Press EQ on the main unit to select
the desirable music style (FLAT, ROCK, POP, JAZZ,
CLASSIC and VOCAL).
Dolby ProLogic II
To provide a an exciting experience while listening to
music, DPL
II provides several advanced setting to
adjust the DPL II Music mode. By modifying the set-
tings, you will be able to adjust the music output
effect according to different Home Theater set up,
recordings and to suit better your personal tastes. The
3 options are Panorama, Dimension and Center
Width.
Dimension control:
Adjust the balance between the rear and front speak-
ers. Depending on the recordings, the sound may be
focused too much on the front or on the rear speak-
ers. Adjusting this parameter will allow a more bal-
ance soundfield.
Center width control:
Control the "weight" or sense of image width of the
sound coming from the center speaker. By adjusting
the variable setting, the sound can only come from
the center speaker or could be progressively blended
into the 2 front speakers.
Panorama mode:
Increase the front stereo imaging by using the rear
speakers to increase the surround and "wraparound"
effect. Select "on" to enable Panorama mode.
To access this setup, press the following sequence:
1. Press SETUP on the main unit to access the Setup
menu.
2. Press arrow keys to scroll the Setup menu until
DPL
II MUSIC appears on the display. Press OK to enter
DPL II setup.
3. Use the Up or Down arrow keys to select the desire
option to set (panorama, dimension, center width).
Then press OK to save your selection.
SETUP TEST TONE EQ DIGITAL INPUT
ST/M SURR. MODE
OPEN/CLOSE
OK
MORY SETUP TEST TONE EQ DIGITAL INP
ST/M
OPEN/CLOSE
NING
OK
MEMORY SETUP TEST TONE E
OPEN/CLOSE
OK
MEMORY SETUP TEST TONE EQ DIG