Technicolor - Thomson Thomson Scenium DPL4000 - Manual (Page 18)

Operating your Receiver
EN
15
Operating the Radio
The receiver has a built-in tuner that allows for
FM/MW/LW radio function.
Manual tuning
1. Connect the FM and AM antenna accordingly (see
"Connecting the Antenna" on page 5 section for
details)
2. Press SOURCE or keys on the main unit
to switch on the receiver from Standby Mode.
3. Press SOURCE or keys on the main unit
or tuner on the remote control to enter TUNER
mode.
4- To select band, press the BAND button on the
main unit or tuner on the remote control to toggle
between FM/MW/LW mode.
5- Tune the stations by pressing TUNING UP or
DOWN on the main unit or REV or FWD on the
remote control repeatedly until the desired station is
found.
Alternatively, you can press and hold the respective
buttons for about one second to activate the
automatic SEARCH function. In this mode the receiver
will automatically tune frequencies until it finds a
station
Select sound effect if needed by pressing Preset EQ or
DSP sound (see "Advance sound section" for details).
Selecting Mono or Stereo Sound
Press ST/M on the main unit or the DIGITAL button
on the remote control to toggle between mono and
stereo sound in FM tuner mode (when available).
BAND TUNING MEMOR
SOURCE
NOTE
1. If there is interference, modify the location
of the antenna until the optimal sound is heard.
TV and other electronic devices could be the
cause of interferences so try to position the
antenna away from them.
2. Weak signal can affect the "auto Search
function". Adjust the antenna for better recep-
tion for more efficient search.
BAND TUNING
SOURCE
OPEN/CLO
BAND TUNING
OK
MEMORY
E
BAND TUN
SOURCE
SETUP TEST TONE EQ DIGITAL INPUT
ST/M SURR. MODE DPS MODE
NOTE
The remote control selector must be set
on hifi.