2 to store a block from a recording, To store a block from a recording – Topfield TF 5400 PVR User Manual
Page 76

70
Recording and Playing
7.4.2
To store a block from a recording
You can store a block from a recording file by performing the
following steps:
1. Start playback of a recording file you want.
2. Press
button to display a progress bar.
3. Find one end position of a block you want to specify
with
button or
button.
4. Press
button at the position, then the pointer starts
to blink.
5. Find the other end position.
6. Press
button at the position again, then a confirma-
tion box appears.
7. Select the Save command, then the block is stored. The
stored file will named after its source file with a suffix of
‘CUT’ and a number
In addition, you can copy a recording file in whole or in part
when playing back it.
1. Start playback of a recording file you want.
2. Find a desired position from which a copy will be started
with
button or
button.
3. Press
button.
4. Pressing
button stops copying. The copied file will
be named after its source file with a suffix of ‘COPY’ and
a number.
Once a copy is started, a copying symbol like the
next figure will be displayed on the right top of the
screen for a few seconds. To see copying status, press
button. The outer circle of the copying symbol indicates
progress rate.