Tektronix AD007 User Manual
Page 65
Reference
AD007 User Manual
51
Reset to the Factory Defaults
The procedure to reset to factory defaults overrides current settings
and sets the adapter to known settings. This makes it possible to
access the adapter from the known settings or to turn DHCP on. You
may reset to Factory defaults either at power on or during normal
operation.
NOTE. If you are not using DHCP, use the factory default settings
only if you are sure they do not conflict with other settings on the
network. If the settings conflict, use the procedure for stand-alone
operation to access the adapter.
To reset at power on, do these steps:
1.
Power the AD007 adapter off.
2.
Use a small tool or end of a paper clip to push in and hold the
reset button.
3.
Power on the AD007 adapter and hold the reset button in until all
status indicators go to a steady amber (approximately 30 se-
conds), then release the button. The AD007 adapter automatically
reboots with the factory defaults.