Tektronix AD007 User Manual

Page 30

Getting Started

AD007 User Manual

When the LAN-Link indicator turns from red to off, the AD007
adapter has successfully loaded the IP address:

GPIB

LAN

LAN-Link

POWER

Off

Green

NOTE. If your Internet web browser is configured to use the dialup
adapter, go into the Internet configuration dialog and change the
browser to use the local network. For more information, refer to the
documentation for your particular system.

In Windows, open the Network Properties window by right-click-
ing on the Network icon in the Control Panel. (In Windows NT,
select the Protocols tab.)

If TCP/IP is not listed as one of the protocols, you must install it
from the Windows installation CD-ROM disc.

Highlight the TCP/IP and click on Properties. This opens the
TCP/IP properties dialog box.

Click on all the tabs and write down all the settings. This allows
you to restore them later if necessary.

10.

Set the IP address of the PC to work with the currently configured
settings of the adapter, or use the following settings that will
work with the factory default settings of the AD007 adapter. (You
may have to click on Specify an IP address.)

Assign the PC an IP address with the first three numbers
that are the same as the current AD007 IP address. (For
example, the IP address 192.168.1.2 is acceptable if you
are using the factory default 192.168.1.1 address of the
adapter).

Assign the numbers for the subnet mask. (For example,
assign the subnet mask 255.255.255.0 if you are using the
factory default settings).